Hi Eros.
I'm using WinXP SP3, Swedish version.
this is the printout from your script:
Code page is now set to: 850
---Chars-------------------------------------------------------
! " # $ % & ' ( ) * + , - . / 0 1 2 3 4 5 6 7 8 9 : ; < = > ? @
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z [ \ ] ^ _ `
a b c d e f g h i j k l m n o p q r s t u v w x y z { | } ~
ˇ ˛
Ŗ * ŗ Ą
Į Ā Ć Ę Ē Č Ź Ė Ģ Ķ Ī Ļ Ń Ņ Ō Ų Ł Ś Ū Ż ą
į ā ć ę ē č ź ė ģ ķ ī ļ ń ņ ō ų ł ś ū ż ˙
Code page is now set to: 1257
---Chars-------------------------------------------------------
! " # $ % & ' ( ) * + , - . / 0 1 2 3 4 5 6 7 8 9 : ; < = > ? @
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z [ \ ] ^ _ `
a b c d e f g h i j k l m n o p q r s t u v w x y z { | } ~
ˇ ˛
Ŗ * ŗ Ą
Į Ā Ć Ę Ē Č Ź Ė Ģ Ķ Ī Ļ Ń Ņ Ō Ų Ł Ś Ū Ż ą
į ā ć ę ē č ź ė ģ ķ ī ļ ń ņ ō ų ł ś ū ż ˙
---Press a key to finish---------------------------------------
E.g. same for both the 850 & 1257 Code Pages... I can not see any update inside thinbasic, the only change I've seen so far is after thinBasic has completed the script end ended. Then is the Code Page updated inside the console. I will try see what I can get for results if I try to do the same in Open Watcom.
To print the letter "" I need to use chr$(142), this when it really is chr$(196) in both Code Page 850, 1257. I can not see any change in any of the 55 Code pages I have installed on my machine...
Could you try to see what result you get on that script?
Bookmarks